General Information
Covers are made to fit customers' pre-made insert. Please specify exact measurements. We always make the cover one inch smaller. If you have a preference please indicate in the 'special instruction' section.
Construction:
Options:
Closure Options: see diagram
Insert Attachment:
Construction:
- Knife edge is standard.
- Edge treatments are not included in the finish measurements.
- Edge treatments can be three sided or four sided. Please specify.
- All seams are finished on the inside to eliminate fraying.
Options:
- Trim or welt inserted into the seam at the edge.
- Flanges can be added, either padded or not. Please specify the width. Not included in the finish measurement of the insert area.
- Any type of banding can be added to the face of the duvet, either at the edge or inset.
Closure Options: see diagram
- Zipper or Velcro at the edge on the reverse side covered with a flap. Please specify top or bottom edge.
- Buttons, either ready made or fabric covered, at the edge.
- Buttons can also be inset approximately ten inches either under a flap or exposed for decorative buttons.
- Please specify location and preferred application.
Insert Attachment:
- Inserts can be attached with Velcro or ties. Some inserts come with snaps but we've never found that snaps work well.
- The insert is needed so that the corresponding attachment can be applied.
- We can provide the insert.
- In our experience ties work the best. We put twelve ties on any insert.
We are always happy to discuss the details, answer any questions and help guide you in your fabric selections.
It is our goal to make your items absolutely fabulous!
It is our goal to make your items absolutely fabulous!